Clearance & capture

Find the right range hood mounting height

Start with the exact hood and range manuals. Measure from the reference surface each manual names, then check that the cabinet layout can satisfy both.

Measure two different clearances

A measures from cooking surface to hood bottom. B checks the vertical distance to overhead material where applicable. Schematic only. Consult the manuals for the exact reference surfaces and check other clearances separately.

A hood's recommended mounting range and a cooking appliance's clearance to cabinets answer different questions. For gas cooking equipment, check your locally adopted fuel gas provisions. The vertical-clearance section commonly numbered G2447.5 addresses overhead material and allows specified exceptions. A generic hood mounting number is not enough to establish that an exception applies. Residential mechanical inspection checklist

Compare the two manuals

Look up the exact model and fuel type in the cooking appliance instructions. Then find the hood's minimum and any upper mounting recommendation or limit. For example, Broan's PM390SSP sheet lists 24–30 inches from the cooktop to the bottom of that hood. That range describes the named hood; it does not set the cabinet clearance or apply to other models. Broan PM390SSP specification (PDF)

Example: Suppose a hood manual permits 24–36 inches and the range requires at least 30 inches to the bottom of that hood. If both refer to the same reference surface and configuration, the overlap is 30–36 inches. Check the cabinets and sidewalls separately. If two applicable requirements leave no overlap, ask the installer to resolve it before ordering.

Check coverage above the burners

Canopy shape, depth and height can affect capture along with airflow. Inspect front-burner coverage and whether cross-drafts could push cooking vapors away from the hood. If a centered 36-inch canopy is placed over a 30-inch cooking surface, its geometric overhang is 3 inches per side. That arithmetic does not establish a universal overhang requirement or measured capture. HVI kitchen ventilation guide

Take these measurements before ordering

  1. Record both model numbers, the manual revisions, and the reference point for each height.
  2. Mark the proposed hood bottom, nearest overhead and side materials, cabinet depth, and burner coverage on the plan.
  3. Confirm the permitted mounting range, duct exit, and any required clearance or protection with the installer.

Check airflow and duct size